Someone had called and asked about what we did to fabricate the Door Skins. They had to be cut and shaped from scratch. I was able to dig up some older pictures of the “custom” units that were crimped and attached to the (altered) Door Frames. Below are some close ups of the top backside section of the Passenger rear Door. It was important to form the shape and crimps to be uniform in width and consistent throughout the entire vehicle. You can see the top section that has already been crimped and the lower section that is still bent in a 90 degree angle. When you look at the crimped sections around the Door edges, they are the same “Factory” width throughout the entire Door perimeter.
Recent Posts
Archives
- December 2017
- November 2017
- October 2017
- July 2017
- June 2017
- May 2017
- April 2017
- March 2017
- February 2017
- January 2017
- December 2016
- November 2016
- October 2016
- September 2016
- August 2016
- July 2016
- June 2016
- May 2016
- April 2016
- April 2015
- March 2015
- February 2015
- January 2015
- December 2014
- November 2014
- September 2014
- August 2014
- May 2014
- April 2014
- March 2014
- February 2014
- November 2013