Here are a few images of the Dash Assembly in place. We dodged a bullet with the calculations on this one. When everything was initially mocked up, the Dash Assembly had about a 3/8″ gap on each side due of the re-fabrication of the lower A Pillar area. Once all of the permanent pieces were in place (A Pillar Vinyl covering, New Dash Pad, Wind-lace material, etc…..) the opening was no longer there and the the pieces fit very tightly into place. They ended up fitting better than anticipated and have the same appearance as Factory engineered components. Sometimes it helps to be lucky and this was one of those “lucky” moments.
You must log in to post a comment.